Sorry
I do not know who to ask about my problem
mdpna-465 with lower overhead bar reinstalled with the wrong ROM
Now it's dead does not come on screen, no PC connection
There are power buttons work
With 9 pin of flash is not starting
I have the original ROM
Please if you can help with ideas, photos, instructions
I can not get him to the world, Booth
pp sorry for bad english
:017::017:
mdpna-465
-
- [GoPal bis 3.x]
- helpos
-
-
-
Ok how does the PNA look like?
Like Picture one
[Blockierte Grafik: http://www.gopal-navigator.de/wiki/images/thumb/9/94/465T-komplett.jpg/788px-465T-komplett.jpg]or Picture two?
[Blockierte Grafik: http://www.gopal-navigator.de/wiki/images/thumb/7/7b/470T-komplett.jpg/788px-470T-komplett.jpg]i mean the bottom side ... Have you this contact "bar" ?
-
Alles anzeigen
Ok how does the PNA look like?
Like Picture one
[Blockierte Grafik: http://www.gopal-navigator.de/wiki/images/thumb/9/94/465T-komplett.jpg/788px-465T-komplett.jpg]or Picture two?
[Blockierte Grafik: http://www.gopal-navigator.de/wiki/images/thumb/7/7b/470T-komplett.jpg/788px-470T-komplett.jpg]i mean the bottom side ... Have you this contact "bar" ?
yes i havePhoto 2 is bottom connector
reinstall it with a ROM of 510 and has finished reinstalling, died
now I have prepared ROM 465t but I can not get him to leave
this is my problem -
?
Does the bottom of your device look like picture one or two?
-
As a user of our board wrote its a 465 with multiconnector.
SO this would be the right download for you:
http://www.gopal-navigator.de/downloads.php?do=file&id=302Do you know how to flash?
I hope you can enter the "blue flash screen" after wrong flashing on your side -
when connecting usb cable LED lights and really charge the battery
Pressing the power after 2-3 seconds coming PSUs 3.3 volts and 1.7 volts for the CPU but display no lights and no connection to PC
Whats happenning when you press both buttons on the right side.. (if there are two buttons present)
Does your device look like:
[Blockierte Grafik: http://bilder4.preissuchmaschine.de/prodfoto/bluemediabm6600.jpg]
?By the way: do you have a GoPal Software for the installation after flashing?
-
There is only one way to enter the boot-menue.
Hold the Power and only the power button on hold until the blue LED blinks up for one time - than it is really OFF.Then press and hold the "Flag" Button pressed. (nothing will happen)
additional (hold the Flag-Button still pressed) press the power button, so you are finally pushing both buttons... The blue menue should appear now.I go to bed now... I hope you get it run..
-
If you did flash your BM with the wrong ROM (510) (i.e. you obviously know the way to flash it) and your PNA doesn't show any reaction while trying to flash once more again I suppose it has been destroyed now. I don't have any ideas left which would help you.
EDIT: ok, probably it might help if you disconnect the accu for about 15 min, but I'm not that hopeful
-
Monika
Hat das Thema aus dem Forum GoPal Software nach MEDION mobile Navis (PNA) verschoben. -
Monika
Hat das Label [GoPal bis 3.x] hinzugefügt.
